SleepIQ

The SleepIQ integration lets you integrate your SleepNumber Bed via SleepIQ by SleepNumber.

Prerequisites

You will need an account on SleepIQ to use this integration.

Configuration

To add the SleepIQ integration to your Home Assistant instance, use this My button:

SleepIQ can be auto-discovered by Home Assistant. If an instance was found, it will be shown as Discovered. You can then set it up right away.

Manual configuration steps

If it wasn’t discovered automatically, don’t worry! You can set up a manual integration entry:

Supported device types

There is currently support available for the following platforms within Home Assistant, depending on the bed’s capabilities:

  • Binary sensor - View occupancy of each side
  • Button - Calibrate the bed
  • Button - Stop the pump
  • Light - Control lights on supported models
  • Number - View/Set the actuator positions of the foundation
  • Number - View/Set firmness for each side
  • Select - Choose a foundation preset position
  • Select/Number - Set a foot warmer mode and timeout
  • Sensor - View pressure of each side
  • Switch - Toggle Privacy mode

Notes

  • If you are using a DNS-based ad-blocker such as Pi-hole, you may need to disable it temporarily while configuring this item in Home Assistant.
  • The Sleep Number bed communicates with endpoints on sleepnumber.com as well as the AWS Firehose data collection service at firehose.us-east-1.amazonaws.com.