2025.1.1
Home ▸ Integrations ▸

EHEIM Digital

The EHEIM Digital integrationIntegrations connect and integrate Home Assistant with your devices, services, and more. [Learn more] allows you to control your EHEIM Digital smart aquarium devices from Home Assistant.

Configuration

To add the EHEIM Digital hub to your Home Assistant instance, use this My button:

EHEIM Digital can be auto-discovered by Home Assistant. If an instance was found, it will be shown as Discovered. You can then set it up right away.

Manual configuration steps

If it wasn’t discovered automatically, don’t worry! You can set up a manual integration entry:

  • Browse to your Home Assistant instance.

  • Go to Settings > Devices & Services.

  • In the bottom right corner, select the Add Integration button.

  • From the list, select EHEIM Digital.

  • Follow the instructions on screen to complete the setup.

Host

The IP address or hostname of your EHEIM Digital main device. Defaults to eheimdigital.local, an IP address should only be necessary if the hostname doesn’t work.

Supported devices and entities

Currently, the following devices and entities are supported:

EHEIM classicLEDcontrol+e

Lights

  • Brightness: Controlling the brightness of both light channels
  • Daycycle mode effect: Automatically controls the brightness based on the daytime as configured on the device

Support for additional EHEIM Digital devices and entities will be added in future updates.

Remove integration

This integration follows standard integration removal, no extra steps are required.

To remove an integration instance from Home Assistant

  1. Go to Settings > Devices & services and select the integration card.
  2. From the list of devices, select the integration instance you want to remove.
  3. Next to the entry, select the three-dot menu. Then, select Delete.